Table of Contents
Advertisement
Step 4. Under Network > Interface, set as shown below:
Click Modify corresponding to Port 4.
Select "DMZ" for Interface Type.
Select "Transparent Bridging" for Connection Type.
Tick the boxes of "Ping/ Tracert", "HTTP" and "HTTPS".
Click OK.
Specifying the Connection Type for the DMZ Interface
Step 5. Go to Network > Interface Group and then set as shown below:
Select "Group 1" for Port1(WAN1) and Port2(LAN1).
Select "Group 2" for Port3(WAN2) and Port4(DMZ1).
Click OK.
After the completion of the above steps, the MH-2300 operates as two
independent switches due to non-interconnected NIC groups, of which Group 1
(Port 1 and 2) provides Internet access to the LAN and Group 2 (Port 3 and 4)
provides Internet access to the DMZ.
Configuring the Interface Group Settings
66
Gigabit Multi-Homing VPN Security Gateway
MH-2300
Advertisement
Table of Contents
