Selection Of The Cycles Via Softkey - Siemens sinumerik 840D sl Operating Manual

Creating G code program

6.8 Selection of the cycles via softkey

6.8 Selection of the cycles via softkey
Overview of the machining steps
The following machining steps are available.
All of the cycles/functions available in the control are shown in this display. However, at a
specific system, only the steps possible corresponding to the selected technology can be
selected.
180
⇒
⇒
⇒
⇒
⇒ ⇒
Operating Manual, 07/2010, 6FC5398-7CP40-0BA0
Turning