Selection Of The Cycles Via Softkey - Siemens SINUMERIK 840D sl Operating Manual

Parameter Description
Y0 1. Rectangular point Y - (only for cuboid)
X1 2. Rectangular point X (abs) or 2nd rectangular point X referred to X0 (inc) - (only for
cuboid)
Y1 2. Rectangular point Y (abs) or 2nd rectangular point Y referred to Y0 (inc) - (only for
cuboid)
ZA Initial dimension
ZI Final dimension (abs) or final dimension in relation to ZA (inc)
ZB Machining dimension (abs) or machining dimension in relation to ZA (inc)
XA Outside diameter – (only for tube and cylinder)
XI Inside diameter (abs) or wall thickness (inc) – (only for tube)
N Number of edges – (only for polygon)
SW or L Width across flats or edge length – (only for polygon)
W Width of the blank - (only for centered cuboid)
L Length of the blank - (only for centered cuboid)
7.7

Selection of the cycles via softkey

Overview of machining steps
The following softkeys are available to insert machining steps.
Universal
Operating Manual, 01/2015, 6FC5398-6AP40-5BA2
⇒
⇒
Creating a G code program
7.7 Selection of the cycles via softkey
Unit
mm
mm
mm
mm
191