Installing
4.1
Procedure for installing the converter
Prerequisites for installing the converter
Check that the following prerequisites are fulfilled before you install the converter:
● Are the components, tools and small parts required for installation available?
● Are the ambient conditions permissible? See Technical data (Page 355).
Installation sequence
1. Mount the converter.
2. If required, mount the line reactor.
3. If required, mount the braking resistor.
4. Connect the following components:
– Converter - motor
– Converter - line reactor - line
– Converter - braking resistor
5. Wire the terminal strip of the control unit.
6. When the installation has been complete and checked, power can then be applied to the
converter.
You start to commission the converter once installation has been completed.
SINAMICS G120C converter
Operating Instructions, 07/2015, FW V4.7 SP3, A5E34263257B AC
4
31