Parameter; A.2 Parameter - Siemens SINAMICS G120C Operating Instructions Manual

A.2

Parameter

Parameters are the interface between the firmware of the converter and the commissioning
tool, e.g. an Operator Panel.
Adjustable parameters
Adjustable parameters are the "adjusting screws" with which you adapt the converter to its
particular application. If you change the value of an adjustable parameter, then the converter
behavior also changes.
Adjustable parameters are shown with a "p" as prefix, e.g. p1082 is the parameter for the
maximum motor speed.
Display parameters
Display parameters allow internal measured quantities of the converter and the motor to be
read.
The Operator Panel and STARTER represent display parameters with an "r" prefix, for
example, r0027 is the parameter for the converter output current.
Commonly used parameters
Table A- 6 Switching to commissioning mode or restore the factory setting
Parameter Description
p0010 Commissioning parameters
0: Ready (factory setting)
1: Perform quick commissioning
3: Perform motor commissioning
5: Technological applications and units
15: Define number of data records
30: Factory setting - initiate restore factory settings
Table A- 7 How to determine the firmware version of the Control Unit
Parameter Description
r0018 The firmware version is displayed:
Table A- 8 How you select the command source and setpoint sources
Parameter Description
p0015 Parameter p0015 allows the setting of pre-defined I/O configurations. Further information is given in the
section: Commissioning using a BOP-2 operator panel (Page 93).
SINAMICS G120C converter
Operating Instructions, 07/2015, FW V4.7 SP3, A5E34263257B AC
Appendix

A.2 Parameter

389