Cycle Data; Data Blocks For Measuring Cycles; General Information; Data Block Gud5.Def - Siemens SINUMERIK 840D sl Programming Manual

Data description

9.2 Cycle data

9.2 Cycle data
9.2.1

Data blocks for measuring cycles

9.2.1.1

General information

The measuring cycle data are stored in two separate definition blocks:
● GUD5.DEF: Data block for measuring cycle users
● GUD6.DEF: Data module for machine manufacturers
Note
As of HMI sl software version 2.6
The GUD parameters are stored in the machine or setting data.
A correspondence/assignment list of the measuring cycle GUD parameters, GUD
modules and measuring programs used up to and including measuring cycles version
7.5, compared to the machine and setting data as of measuring cycles version 2.6, is
included in appendices A1, A2 and A3.
9.2.1.2

Data block GUD5.DEF

The input and output parameters for measuring cycles are stored in the data block
GUD5.DEF; their status flags and arrays for the empirical and mean values are also defined
here.
The sizes of the fields for the empirical and mean values must also be configured by the
machine manufacturer at measuring cycle start-up.
The preset values, however, are defined by the measuring cycle operator.
In the as-delivered state, for example, the following settings are active:
Data arrays
_EV[20]
_MV[20]
9.2.1.3

Data block GUD6.DEF

The general, global, and channel-specific measuring cycle data are configured in the
GUD6.DEF data block.
This block is supplied with the measuring cycles in its standard configuration and must be
adapted to the specific requirements of the machine by the machine manufacturer.
In the as-delivered state, the following settings are active:
378
Data type Meaning
REAL Number of empirical values
REAL Number of mean values
Programming Manual, 03/2009 Edition, 6FC5398-4BP10-2BA0
Measuring cycles