Siemens SINUMERIK 840D sl Programming Manual page 128

Measuring Cycles for Milling and Machining Centers
5.3 CYCLE976 calibrate workpiece probe
Parameter
Parameter
_MVAR
_SETVAL
_PRNUM
_STA1
The following additional parameters are also valid:
_VMS, _CORA, _TZL, _TSA, _FA and _NMSP.
_CORA only relevant for monodirectional probe.
See also
Variable measuring velocity: _VMS (Page 76)
Offset angle position: _CORA (Page 76)
Tolerance parameters: _TZL, _TMV, _TUL, _TLL, _TDIF and _TSA (Page 77)
Multiple measurement at the same location: _NMSP (Page 81)
128
Data type
xx0x08
REAL, >0
>0
REAL
Meaning
Calibration in hole, center unknown
Calibration setpoint = diameter of hole
Probe number
Starting angle, only for MVAR=1xxx08
(calibration performed at this angle)
Programming Manual, 03/2009 Edition, 6FC5398-4BP10-2BA0
Measuring cycles