Result Bit; Programming Using Parameters - Siemens SINUMERIK 840D sl Programming Manual

5.10.6.4

Result bit

If the "Calculate kinematics" selection is active, a result bit can be selected in the screen
form for CYCLE996 as follows:
● No: After calculating/measuring, the results are not displayed.
● Yes: After calculation/measuring, the message display appears; the individual values on
● Yes, editable: The result parameters can be changed (and potentially rounded off).
If the tolerance parameters <> 0, the relevant fields are displayed in red when they are
exceeded (comparison from $TC_CARR1...with _OVR[1...]).
The calculated/measured _OVR-Parameter are always displayed in the result bit.
5.10.7

Programming using parameters

5.10.7.1 Programming using parameters
CYCLE996 programming with "1st, 2nd, 3rd measurement"
_MVAR, _TNUM, _SETVAL, _FA, _TSA, _VMS, _PRNUM, _SETV[3], _SETV[4]
CYCLE996
CYCLE997 is called internally within CYCLE996 for the purpose of measuring the calibration
ball. Parameters _SETVAL, _FA, _TSA, _VMS and _PRNUM feed CYCLE997.
CYCLE996 programming with "Calculate kinematics"
_MVAR, _TNUM, _SETV[5], _SETV[6], _SETV[7], _SETV[8]
CYCLE996
Measuring cycles
Programming Manual, 03/2009 Edition, 6FC5398-4BP10-2BA0
this display cannot be edited.
Measuring Cycles for Milling and Machining Centers
5.10 CYCLE996 workpiece: Measure kinematics
253