Data Description; Machine Data For Machine Cycle Runs - Siemens SINUMERIK 840D sl Programming Manual

Data description

9.1

Machine data for machine cycle runs

For descriptions of the machine data for the sequence of measuring cycles for HMI as of
software version 2.6, see:
References:
Commissioning Manual SINUMERIK 840d HMI sl base software and HMI sl;
Book HMI sl (IM9)
Chapter on measuring cycles
Note
As of HMI sl software version 2.6
The GUD parameters are stored in the machine or setting data.
A correspondence/assignment list of the measuring cycle GUD parameters, GUD modules
and measuring programs used up to and including measuring cycles version 7.5, compared
to the machine and setting data as of measuring cycles version 2.6, is included in
appendices A1, A2 and A3.
Measuring cycles
Programming Manual, 03/2009 Edition, 6FC5398-4BP10-2BA0
9
377