Programming Example - Siemens SINUMERIK 840D sl Programming Manual

See also
Defining parameters (Page 63)
Result parameters (Page 65)
Variable measuring velocity: _VMS (Page 76)
Tolerance parameters: _TZL, _TMV, _TUL, _TLL, _TDIF and _TSA (Page 77)
Measurement path: _FA (Page 78)
Multiple measurement at the same location: _NMSP (Page 81)
6.4.2.2

Programming example

Calibrate workpiece probe in reference groove
The workpiece probe 1 with cutting edge position SL=7 is to be calibrated in reference
groove 1 in both axes and in both directions in X. The probe is inserted as tool T8, D1.
Probe lengths L1 and L2 always refer to the probe ball center and must be entered in the
tool offset memory before the measuring cycle is called, T8, D1:
Tool type (DP1):
Cutting edge position (DP2):
Length 1 - geometry (DP3):
Length 2 - geometry (DP4):
Radius - geometry (DP6):
The data for reference groove 1 have already been entered:
_KB[0,0] = 60.123, _KB[0,1] = 50.054,
_KB[0,2] = 15.021
Measuring cycles
Programming Manual, 03/2009 Edition, 6FC5398-4BP10-2BA0
Measuring Cycles for Turning Machines
6.4 CYCLE973 Calibrating workpiece probes
580
7
L1 = 40.123
L2 =
100.456
3.000
327