1.7.3
Measuring workpieces at the turning machines
Workpiece probe
On turning machines, the workpiece probes are treated as tool type 5xy with permissible
cutting edge positions (SL) 5 to 8 and must be entered in the tool memory accordingly.
Lengths specified for turning tools always refer to the tool tip, except in the case of
workpiece probes on turning machines where they refer to the probe center.
Probes are classified according to their position:
Workpiece probe SL 7
Entry in tool memory
Tool type (DP1):
Cutting edge position (DP2):
Length 1 - geometry:
Length 2 - geometry:
Radius (DP6):
Length 1 - basic measurement
(DP21):
Length 2 - basic measurement
(DP22):
The wear and other tool parameters must be assigned the value 0.
Workpiece probe SL 8
Entry in tool memory
Tool type (DP1):
Cutting edge position (DP2):
Length 1 - geometry:
Length 2 - geometry:
Radius (DP6):
Length 1 - basic measurement
(DP21):
Length 2 - basic measurement
(DP22):
The wear and other tool parameters must be assigned the value 0.
Measuring cycles
Programming Manual, 03/2009 Edition, 6FC5398-4BP10-2BA0
1.7 Probe, calibration body, calibration tool
5xy
7
L1
L2
r
only if required
X
only if required
5xy
8
L1
L2
r
only if required
only if required
General
F
L2
L2
Z
27