Siemens SINUMERIK 840D sl Programming Manual page 455

Central bits
Block Identifier
GUD6 _CBIT[2]
GUD6 _CBIT[3]
GUD6 _CBIT[4]
GUD6 _CBIT[5]
GUD6 _CBIT[6]
GUD6 _CBIT[7]
GUD6 _CBIT[8]
GUD6 _CBIT[9]
GUD6 _CBIT[10]
GUD6 _CBIT[11]
GUD6 _CBIT[12]
GUD6 _CBIT[13]
GUD6 _CBIT[14]
GUD6 _CBIT[15]
Measuring cycles
Programming Manual, 03/2009 Edition, 6FC5398-4BP10-2BA0
Description
M0 for tolerance alarms "oversize", "undersize", "permissible dimensional
difference exceeded"
0: no generation of M0 for the above alarms
1: generation of M0 for the above alarms
currently not assigned
currently not assigned
Tool measurement and calibration in the WCS in CYCLE982
(from measuring cycles SW 5.4)
0: machine-related measurement and calibration
1: workpiece-related measurement and calibration
Note: In both cases, the _TP[ ] field of the probe is used.
From measuring cycles SW 6.3, function switchover via _MVAR is
available.
Logging without output of the measuring cycle name and measuring
variant
(from measuring cycles SW 6.2)
0: Measuring cycle name and measuring variant will be output.
1: These outputs will be suppressed.
currently not assigned
Offset of the mono probe setting
0: No compensation
1: offset of spindle by angle _CORA,
Assigned internally
currently not assigned
Selection of log header for logging
0: Standard
1: user-defined
Feed and speed in CYCLE971
0: calculation by measuring cycle itself
1: set by user in array _MFS[ ]
currently not assigned
Length reference of the workpiece probe in milling measuring cycles
(from measuring cycles SW 4.5)
0: length relative to probe ball center
1: length relative to end
Transfer of workpiece probe data into the tool offset in CYCLE976 (from
measuring cycles SW 4.5)
0: No transfer
1: result of probe ball calculation on calibration will be entered in the
geometry memory of the workpiece probe (radius)
A.4 Overview of measuring cycle parameters
Appendix
As-delivered
value
0
0
0
0
0
0
0
0
0
0
0
0
0
0
455