Siemens SINUMERIK 840D sl Programming Manual page 318

Measuring Cycles for Turning Machines
6.3 CYCLE982 tool: Measure turning and milling tools
Programming example
Measuring the turning tool automatically (machine-related, measuring cycle release SW 7.3
and higher)
Approximate values for the lengths and
radius of tool T1 are known and entered in
offset field D1. The cutting edge position in
the tool offset must be entered in
accordance with the basic position of the
tool carrier; in this case, cutting edge
position 3.
The tool should be measured in cutting
edge position 4; the tool is aligned in
relation to this.
Values of the turning tool T1 D1:
Tool type (DP1):
Cutting edge length (DP2):
Length 1 - geometry (DP3):
Length 2 - geometry (DP4):
Radius - geometry (DP6):
Deviations from this value of less then 2.5
mm are expected.
The probe to be used is tool probe 1. This
probe has already been completely
calibrated (machine-related). The precise
values are entered in data field _TP[0,...]
and are:
_TP[0.0] = 220, _TP[0.1] = 200
_TP[0.2] = 400, _TP[0.3] = 380
318
Basic position of the tool carrier:
Turning tool Cutting edge position 3
500
3
L1 = 10
L2 = 40
R = 0.5
Aligned tool:
Turning tool Cutting edge position 4
Programming Manual, 03/2009 Edition, 6FC5398-4BP10-2BA0
Measuring cycles