Siemens SINUMERIK 840D sl Programming Manual page 5

Note
Country telephone numbers for technical support are provided under the following Internet
address:
http://www.automation.siemens.com/partner
Questions about the manual
If you have any queries (suggestions, corrections) in relation to this documentation, please
fax or e-mail us:
Fax
E-mail
A fax form is available in the appendix of this document.
Internet address
http://www.siemens.com/motioncontrol
Validity
This User's Guide is valid for the following controls:
Measuring cycles, version 02.06.
Structure of descriptions
All cycles and programming options have been described according to the same internal
structure, as far as this is meaningful and practicable. The various levels of information have
been organized such that you can selectively access the information you need for the task in
hand.
Supplementary devices
The applications of SIEMENS controls can be expanded for specific purposes through the
addition of special add-on devices, equipment and expansions supplied by SIEMENS.
Note
Measuring cycles GUD parameters
A correspondence/assignment list of the measuring cycle GUD parameters, GUD modules
and measuring programs used up to and including measuring cycles version 7.5, compared
to the machine and setting data as of measuring cycles version 2.6, is included in
appendices A1, A2 and A3.
Measuring cycles
Programming Manual, 03/2009 Edition, 6FC5398-4BP10-2BA0
+49 9131- 98 2176
mailto:docu.motioncontrol@siemens.com
Preface
5