Example Of The Procedure To Measure The Kinematics (Cycle996) - Siemens SINUMERIK 840D sl Programming Manual

5.10.3

Example of the procedure to measure the kinematics (CYCLE996)

By way of illustration, the BC table kinematics measurement process (both rotary axes move
the workpiece) is described below:
● The two rotary axes can only be adjusted mechanically (workholder with orientation
● The computed values are archived in TCARR data.
General procedure
● Create/check TCARR data:
● Mount calibration ball on the clamping device
● Load and activate the probe in the spindle
● Calibrate the probe using CYCLE976 or "Calibrate probe". Measure in JOG mode
Procedure for approaching positions
Measuring cycles
Programming Manual, 03/2009 Edition, 6FC5398-4BP10-2BA0
capability)
MD 18088 MM_NUM_TOOL_CARRIER > = 1?
Measuring Cycles for Milling and Machining Centers
5.10 CYCLE996 workpiece: Measure kinematics
243