Siemens SINUMERIK 840D sl Programming Manual page 457

Channel-specific values (for measuring in JOG, GUD7_MC)
Block Identifier
GUD7 E_MESS_MIN_F
GUD7 E_MESS_MIN_F_FAK1
GUD7 E_MESS_MIN_F_FAK2
GUD7 E_MESS_MIN_D
GUD7 E_MESS_MS_MONO
GUD7 E_MESS_MS_SOUTH
GUD7 E_MESS_MT_TYP[3]
GUD7 E_MESS_MT_AX[3]
GUD7 E_MESS_MT_DL[3]
GUD7 E_MESS_MT_DR[3]
GUD7 E_MESS_MT_DZ[3]
GUD7 E_MESS_MT_DIR[3]
GUD7 E_MESS_MT_D
GUD7 E_MESS_MT_FM
GUD7 E_MESS_MT_CF
GUD7 E_MESS_MT_COMP
GUD7 E_MESS[3]
GUD7 E_MEAS
GUD7 E_MESS_RETT
GUD7 E_MESS_SETT[10]
GUD7 E_MESS_AM
1) During installation value input is mandatory here!
Measuring cycles
Programming Manual, 03/2009 Edition, 6FC5398-4BP10-2BA0
Description
Min. feed for measuring with rotating spindle for the 1st
probing [mm/min]
On tool measurement with rotating spindle, traversal
with 10 times measuring feed is performed in the 1st
probing (limitation by E_MESS_MAX_F) [mm/min]
For tool measurement with rotating spindle, 2nd probing
is performed with measuring feed. There is no 3rd
probing [mm/min]
Measuring accuracy for measuring with rotating spindle
[mm/min]
Probe is treated as multi probe
Probe is used with reference to the probe sphere end
Type of tool probe
Permissible axis directions for tool probe
Diameter of tool probe for length measurement
1)
Diameter of tool probe for radius measurement
1)
Infeed for measurement tool probe diameter
Approach direction in the plane tool probe
Calibrate measurement path for tool probe and tool
measurement with motionless spindle (before and after
expected switching position)
Calibrate measuring feed for tool probe and tool
measurement with motionless spindle
No tool probe make (manufacturer) specified
No offset of the measurement result on tool
measurement with rotating spindle
Internal data item
Internal data item
Internal data item
Field for settings
Internal data item
A.4 Overview of measuring cycle parameters
Appendix
As-delivered value
1
10
0
0.01
0
1
0
133
0
0
2
-1
10
100
0
0
457