Siemens SINUMERIK 840D sl Programming Manual page 345

Tool type (DP1):
Cutting edge position (DP2):
Length 1 - geometry (DP3):
Length 2 - geometry (DP4):
Radius - geometry (DP6):
%_N_REVERSALMEAS_MPF
N10 G54 G90 G18 T9 D1 DIAMON
N20 G0 Z30 X90
N30 _MVAR=1000 _SETVAL=45 _TUL=0 _TLL=-0.01
_MA=2 _STA1=0 _KNUM=1 _TNUM=7 _EVNUM=0
_TZL=0.002 _TDIF=0.4 _TSA=1 _PRNUM=1 _VMS=0
_NMSP=1 _FA=2
N40 CYCLE974
N50 G0 Z110
N60 X90
N100 M2
Note
The values of the workpiece tolerance parameters _TUL, _TLL were selected asymmetrically
in the example. The result is then made symmetrical (see Section "Tolerance parameters:
_TZL, _TMV, _TUL, TLL, _TDIF and _TSA").
Measuring cycles
Programming Manual, 03/2009 Edition, 6FC5398-4BP10-2BA0
Measuring Cycles for Turning Machines
6.5 CYCLE974 workpiece: 1-point measurement
580
7
L1 = 40.123
L2 =
100.456
3.000
;Call ZO, tool = probe
;Preposition probe
;Parameters for cycle call
;Measuring cycle call
;Retraction in Z
;Retraction in X
;End of program
345