Siemens SINUMERIK 840D sl Programming Manual page 219

Parameter
Parameter
_MVAR
_FA
_KNUM
_ID
_SETV[0]
_SETV[1]
_SETV[2]
_SETV[3]
_SETV[4]
_SETV[5]
_SETV[6]
_SETV[7]
The following additional parameters are also valid:
_VMS, _PRNUM, and _NMSP.
See also
Variable measuring velocity: _VMS (Page 76)
Probe type, probe number: _PRNUM (Page 79)
Multiple measurement at the same location: _NMSP (Page 81)
Measuring cycles
Programming Manual, 03/2009 Edition, 6FC5398-4BP10-2BA0
5.8 CYCLE961 workpiece: Setup inside and outside corner
Data type Meaning
117 Set up internal corner, specify 4 points
118 Set up external corner, specify 4 points
REAL Measurement path
0, >0 0: without automatic ZO correction
>0: with automatic ZO correction
(Individual values: see Parameter description section "Description of
the most important defining parameters"., Parameter _KNUM)
REAL Incremental infeed in applicate for measuring depth
REAL Abscissa P1 in active WCS
REAL Ordinate P1 in active WCS
REAL Abscissa P2 in active WCS
REAL Ordinate P2 in active WCS
REAL Abscissa P3 in active WCS
REAL Ordinate P3 in active WCS
REAL Abscissa P4 in active WCS
REAL Ordinate P4 in active WCS
Measuring Cycles for Milling and Machining Centers
219