Siemens SINUMERIK 840D sl Programming Manual page 423

CYCLE961
_SETV[4]
REAL
_SETV[5]
REAL
_SETV[6]
REAL
_SETV[7]
REAL
_STA1
REAL
0...360
degrees
_SZA
REAL
_SZO REAL
_TDIF
REAL
_TMV
REAL
_TNAME
STRING[ ]
_TNUM INT
_TUL
REAL
_TLL
REAL
_TSA
REAL
_TZL REAL
_VMS
REAL
>=0
See also
Comparison of GUD parameters up to measuring cycles version 7.5 and GUD parameters
as of measuring cycles version 2.6, with reference to measuring function. (Page 413)
GUD variables that can no longer be used (Page 418)
Changes to names of cycle programs and GUD modules (Page 420)
Measuring cycles
Programming Manual, 03/2009 Edition, 6FC5398-4BP10-2BA0
Workpiece measurements
1: Measured corner
2: Offset in abscissa
3: Offset in abscissa
and ordinate
4: Offset in ordinate
---- ----
---- ----
---- ----
Approx. angle of posit. direction of the abscissa with
respect to 1st edge of the workpiece
(reference edge), clockwise negative
---- ----
---- ----
---- ----
---- ----
---- ----
---- ----
---- ----
---- ----
---- ----
---- ----
(for _VMS=0: 150 mm/min (if _FA=1); 300 mm/min (if _FA>1))
A.4 Overview of measuring cycle parameters
---- ----
---- ----
----
---- ----
---- ----
---- ----
---- ----
---- ----
---- ----
---- ----
---- ----
---- ----
---- ----
---- ----
Variable measuring velocity
Coordinates of point P3 in the active
workpiece coordinate system
(abscissa)
Coordinates of point P3 in the active
workpiece coordinate system
(ordinate)
Coordinates of point P4 in the active
workpiece coordinate system
(abscissa)
Coordinates of point P4 in the active
workpiece coordinate system
(ordinate)
---- ----
----
----
----
----
----
----
----
----
----
----
Appendix
----
----
----
----
----
----
----
----
----
----
423