Siemens SINUMERIK 840D sl Programming Manual page 321

%_N_MESSEN_FW_MPF
;$PATH=/_N_WKS_DIR/_N_WZ_MESSEN_WPD
N10 G0 G54 G18 G40 G90 G94 DIAMOF
N20 _CHBIT[3]=1
N30 T10 D1
N40 Z200 X200
N50 CYCLE800(0,"TURN",300,57,0,0,0,0,-
90,0,0,0,0,-1,)
N60 Z200 X200
N70 _MVAR=11 _ID=0 _PRNUM=1 _FA=3 _TSA=3
_TDIF=2 _TZL=0 _VMS=0 _NMSP=1 _EVNUM=0
N80 CYCLE982
N90 M30
Explanation of example
After approaching the starting position for alignment, the tool is aligned with CYCLE800 (see
Programming Manual "Cycles", function "Tool alignment"). The tool is aligned from the radial
tool position when the tool carrier is in its basic position to an axial position. Following
alignment, the starting position for measurement is approached. The measuring procedure
and the offset strategy that follow are the same as for the measuring variants when the tool
carrier is in its basic position.
Note
The following measuring variants are not supported when using an orientational tool carrier:
• Automatic measurement of milling tools, particularly of the upper cutting edge
When this measuring variant is used, alarm 61307: "Incorrect measuring variant" is output.
Measuring cycles
Programming Manual, 03/2009 Edition, 6FC5398-4BP10-2BA0
– _MVAR=x3xx2 and
– _MVAR=x4xx2.
Measuring Cycles for Turning Machines
6.3 CYCLE982 tool: Measure turning and milling tools
;Offset in wear
;Selection of the tool to be
measured
;Starting position for alignment
;Align tool
;Starting position for measurement
;Measure tool L1
321