Siemens SINUMERIK 840D sl Programming Manual page 403

Measured value offset in CYCLE994
_CHBIT[7]=0:
_CHBIT[7]=1:
Offset mode for workpiece measurement with automatic tool offset
_CHBIT[8]=0:
_CHBIT[8]=1:
Measuring result display
_CHBIT[10]=0:
_CHBIT[10]=1:
Acknowledgment measurement result screen with NC start
_CHBIT[11]=0:
_CHBIT[11]=1:
Static measurement result display
_CHBIT[18]=0:
_CHBIT[18]=1:
Measuring cycles
Programming Manual, 03/2009 Edition, 6FC5398-4BP10-2BA0
In order to determine the actual value, the trigger values of the measuring probe,
saved in the _WP[_PRNUM-1,1...4) are used.
In order to determine the actual value, the effective diameter of the measuring
probe, saved in the _WP[_PRNUM-1,0] is used.
Explanation --> see _CHBIT[6]
Explanation --> see _CHBIT[6]
OFF
ON
After measuring or calibrating, a measurement result screen is automatically
displayed.
The measurement result screen is automatically de-selected at the end of the
cycle. Also _CHBIT[18] must be =0, otherwise the effect as described for
_CHBIT[18]=1 is obtained.
After the measurement result screen is displayed, the cycle generates M0. The
measurement cycle is continued and the screen is de-selected after the NC start.
Effect is defined by _CHBIT[11].
The measurement result screen display is kept until the next measuring cycle is
called. NC program processing is not interrupted.
_CHBIT[10] must be set, _CHBIT[11] must be 0!
Data description
9.2 Cycle data
403