Replacing The Nt4N39Aa Cp Piv Call Processor Card - Nortel 1000E Maintenance Manual

8
9
10
11
12
13

Replacing the NT4N39AA CP PIV Call Processor card

Procedure 20
Replacing the NT4N39AA CP PIV Call Processor card
Step
1
Copyright © 2007, Nortel Networks
.
Replacing the NT4N39AA CP PIV Call Processor card 125
Use a small-bladed screwdriver to replace the screws on the card.
Replace all cables on the replaced CP PII card.
Before continuing with this procedure, you must reinstall the software from
CD-ROM. See "Installing software" procedures in Communication Server
1000M and Meridian 1: Large System Installation and Configuration
(553-3021-210), Release 4.0.
After the inactive Call Server reloads, check status in LD 135:
STAT CPU
In LD 135, on the active Call Server, rejoin the two CP PII cards:
JOIN
After the disk sync and memory sync complete, enter the following
in LD 135:
STAT CPU
In LD 135, verify that the replaced CP PII card can control call
processing:
SCPU
Note: Switch Call Server back, if necessary.
Action
Check the System Utility card maintenance display to verify that the
Call Server containing the CP PIV card to be replaced is inactive.
If the Call Server containing the CP PIV card is active, switch Call
Servers in LD 135:
LD 135
SCPU
Nortel Communication Server 1000
Communication Server 1000E Maintenance
NN43041-700 01.02 Standard
Release 5.0 20 June 2007
ATTENTION
To check for normal system operation.
To check replaced CP PII.
—End—
Load the program.
Switch Call Servers (if necessary).