Replacing The Ntag26 Equipment Card - Nortel 1000E Maintenance Manual

4
5

Replacing the NTAG26 equipment card

Procedure 36
Replacing the NTAG26 equipment card
Step
1
2
3
4
5
Copyright © 2007, Nortel Networks
.
After you install cards, the red LED on the faceplate flashes as a
self-test runs. If the self-test succeeds, the card is automatically
enabled (if it is configured in software) and the LED turns off. If the
self-test fails, the LED lights steadily and remains lit.
Software-enable the card by entering: ENLC l s c
When the process is complete, a system response appears.
To end the program, enter four asterisks (****).
Action
Software-disable the card with the following command:
LD 34 DISC l s c
Unhook the locking devices on the card. Pull it out of the card cage.
Insert the replacement card into the vacant slot and hook the locking
devices.
After you install cards, the red LED on the faceplate flashes as a
self-test runs. If the self-test succeeds, the card is automatically
enabled (if it is configured in software) and the LED turns off. If the
self-test fails, the LED lights steadily and remains lit.
Software-enable the card by entering: ENLC l s c
When the process is complete, a system response appears.
To end the program, enter four asterisks (****).
Nortel Communication Server 1000
Communication Server 1000E Maintenance
NN43041-700 01.02 Standard
Release 5.0 20 June 2007
Replacing the NTAG26 equipment card 143
—End—
—End—