Replacing Ntdw61 Cp Pm Signaling Server Equipment; Cp Pm Signaling Server Card Replacement - Nortel 1000E Maintenance Manual

5
6
7
8

Replacing NTDW61 CP PM Signaling Server equipment

Replacing a defective Signaling Server
Replacing a defective CS 1000 Release 5.0 Signaling Server requires
that you perform a migration of the Signaling Server from one hardware
platform to another.
For detailed instructions about how to replace a defective Signaling Server,
see Signaling Server Installation and Commissioning (NN43001-312).
Replacing the hard drive on a CP PM Signaling Server
For detailed instructions about how to replace the hard drive on a CP PM
Signaling Server, see Signaling Server Installation and Commissioning
(NN43001-312).

CP PM Signaling Server card replacement

Before you replace a CP PM Signaling Server card, you must perform the
following tasks:
•
•
•
Copyright © 2007, Nortel Networks
.
Replacing NTDW61 CP PM Signaling Server equipment 113
Slide the CP PM Call processor into Slot 1 (or higher) of the chassis.
Slot 1 provides for easiest cabling.
Lock the card into the faceplate latches.
Reconnect all cables.
To install Call Server software, see Communication Server 1000E
Installation and Commissioning (NN43041-310).
Use a Web browser to download the most recent version of the software
from:
www.nortel.com\support
Create a bootable RMD with software on it.
For more information, see
114).
Back up the NRS database.
For more information, see
Nortel Communication Server 1000
Communication Server 1000E Maintenance
NN43041-700 01.02 Standard
Release 5.0 20 June 2007
—End—
"Create a bootable RMD with software" (page
"Back up the NRS database" (page 114).