Nortel 1000E Maintenance Manual page 19

Figure 1
CS 1000E local and remote access system terminals
With the CS 1000E, a system terminal can also connect directly to the Call
Server, Signaling Server, Media Cards, and Media Gateway 1000T (MG
1000T).
When a system terminal is installed directly on the CP PII or CP PIV Call
Server, it connects to the com 1 port.
When a system terminal connection is made to a CP PM Call Server, the
com (SDI) port is routed through the backplane of the shelf to the 50 pin
MDF connector. The NTAK19EC cable ships with the CP PM that adapts the
50 pin MDF to a 25 pin DB connector for connectivity. A 25 pin null modem
cable is required to adapt the SDI port to a typical PC serial port. Port0 is
used for maintenance access. Port1 is for an external modem connection.
When a system terminal is installed on the Signaling Server, the rear serial
port is the primary port for maintenance and administration.
When a system terminal connects to an MG 1000E, it connects to the Small
System Controller (SSC) through an SDI port on the rear of the MG 1000E.
The Voice Gateway Media Card faceplate provides a female 8-pin mini-DIN
serial maintenance port for system terminal connection. The maintenance
port on the Shielded 50-pin to Serial/ELAN/TLAN Adapter (L-Adapter)
provides an alternative to the faceplate maintenance port. For details, see
the Voice Gateway Media Card installation in Communication Server 1000E
Installation and Commissioning (NN43041-310).
Copyright © 2007, Nortel Networks
.
System terminal access for CP PII and CP PIV Call Servers 19
Nortel Communication Server 1000
Communication Server 1000E Maintenance
NN43041-700 01.02 Standard
Release 5.0 20 June 2007