Telephony Manager - Nortel 1000E Maintenance Manual

22 Communicating with the system
MG 1000E card slot assignment
The MG 1000E contains physical card slots numbered 1 to 10. When
configuring the CS 1000 system, the physical card slot numbers must be
transposed to loop, shelf, card.
Connecting to the Media Card RS-232 maintenance port
Connect a serial cable either to the rear P2 connector or to the faceplate
connector, but not both. The card's hardware cannot support two devices
connected at the same time.
The terminal device should be configured to 9600, 8, N, 1. Configure the
flow control to "None" or a similar setting.
If the hardware flow control is enabled, you see information from the card
but the card does not respond to any keystrokes. If this happens, ensure the
flow control is set to "None", close the session, and reopen it.

Telephony Manager

Telephony Manager (TM) is a management server used to configure and
maintain the system. It collects and processes alarms from the system,
collects call accounting and traffic data, and acts as a terminal server for
multiple devices.
CS 1000 systems can be accessed directly using TM. Each CS 1000
appears as a separate system in the network. The Call Server appears as
one of the following:
•
•
•
•
•
TM provides alarm management and maintenance applications.
Alarm management
TM alarm management provides an alarm collection and a processing
center for multiple systems and devices. TM receives Simple Network
Management Protocol (SNMP) traps from the CS 1000 system, and stores
them in a circular log file on the TM Server. The TM Alarm Notification
application monitors incoming traps and notifies you of important events
and alarms.
Copyright © 2007, Nortel Networks
.
Communication Server 1000M Multi Group CP PIV
Communication Server 1000E Multi Group CP PIV
Communication Server 1000M Multi Group CP PII
Communication Server 1000E Multi Group CP PII
Communication Server 1000E CP PM
Nortel Communication Server 1000
Communication Server 1000E Maintenance
NN43041-700 01.02 Standard
Release 5.0 20 June 2007