Nortel 1000E Maintenance Manual page 25

On the Call Server, the device can be connected through the Terminal
Server or through a Com port. If the RS-232 device is connected directly to
the Call Server Com port, a separate terminal is required to communicate
with each Call Server in the Core.
On the MG 1000T Core, the device is connected directly to the Media
Gateway SDI port using the NTBK48 three-port cable. (See Communication
Server 1000E Installation and Commissioning (NN43041-310) for details.)
When you access the system through a system terminal, a login procedure
is required. All system passwords are initially set to"0000". Change
passwords in the Configuration Record in LD 17. If a system reload
(sysload) occurs before the new password is saved in a data dump, the
last active password remains valid.
Accessing the system from an SDI system terminal
To access the system from an SDI system terminal, follow the steps in
Procedure 1 "Accessing the system from an SDI system terminal" (page
Procedure 1
Accessing the system from an SDI system terminal
Step
1
2
3
4
5
6
7
Copyright © 2007, Nortel Networks
.
Action
Press Return.
a. If the response is OVL111 nn IDLE or OVL111 nn BKGD, you
are ready to log into the system. Go to
b. If the response is OVL000 > , you are already logged into the
system. Go to step
Responses vary with different Background Terminal packages.
Enter LOGI ADMIN1 and press Return.
The normal response is PASS?. If there is any other response, see
Software Input/Output Reference – Maintenance (NN43001-711).
Enter either the level 1 or level 2 password and press Return. If the
password is correct, the system responds with the prompt >.
Enter LD xx, where xx represents the number of the program.
Perform tasks.
To end the program, enter four asterisks (****).
To end the login session, enter LOGO.
Nortel Communication Server 1000
Communication Server 1000E Maintenance
NN43041-700 01.02 Standard
Release 5.0 20 June 2007
Accessing the system 25
step
4.
—End—
25).
2.