Nortel 1000E Maintenance Manual page 65

Command
rmonstatshowall
swversionshow
Local access to the MGC debug shell
For more detail about configuring MGC serial ports, see Communication
Server 1000E Installation and Commissioning (NN43041-310)
When you connect to an MGC TTY that is not configured as a system
terminal, you receive no system prompt.
When you connect to an MGC TTY that is configured as a system terminal,
you automatically connect to the Call Server SL1 shell.
In either situation, the commands in the following table provide access to
the LDB and OAM shells.
Table 18
Accessing MGC debug shells
Command
Ctrl+l, Ctrl+d, Ctrl+b
Ctrl+o, Ctrl+a, Ctrl+m
Ctrl+o, Ctrl+a, Ctrl+m
Ctrl+l, Ctrl+d, Ctrl+b
exit
To access the Call Server Problem Determination Tool (PDT), enter Ctrl+p,
Ctrl+d, Ctrl+t on an MGC TTY configured as a system terminal.
Remote access to the MGC debug shell
Release 5.0 of CS 1000 supports rlogin, telnet, FTP, and secure shell (ssh)
for remote access to the Media Gateway Controller.
For remote access to the MGC, initiate an rlogin or telnet session from the
remote host to the ELAN address of the MGC.
The commands in
function remotely and locally.
Copyright © 2007, Nortel Networks
.
Media Gateway Controller Local Diagnostic Shells 65
Shell Description
LDB1 Displays RMON statistics collected by the embedded Ethernet
switch for all ports.
LDB1 Displays the versions of all software and loadware currently in
service on the MGC.
Description
Obtain an LDB prompt.
Obtain an OAM prompt.
Obtain an OAM prompt from the LDS command line. The LDS
session terminates after a successful logon to OAM.
Obtain an LDS prompt from the OAM command line. The OAM
session terminates after a successful logon to LDB.
Exit LDB or OAM.
Table 18 "Accessing MGC debug shells" (page 65)
Nortel Communication Server 1000
Communication Server 1000E Maintenance
NN43041-700 01.02 Standard
Release 5.0 20 June 2007