Nortel 1000E Maintenance Manual page 106

106 Database management
Procedure 10
Restoring or updating the configuration database (system operating)
Step
1
2
Copyright © 2007, Nortel Networks
.
R>
CCCCCCCCCC
When the file verification succeeds, the system responds OK.
If the file verification fails, the system responds with one of the
following:
Mismatch in the data file.
BKP0002
Corrective action:
•
•
Some transferring data is invalid. Data transfer is not
BKP0003
attempted.
Corrective action: Repeat the backup procedure from
the beginning (EDD).
Some transferring data is invalid. Data transfer is not
BKP0003
attempted.
Corrective action: Repeat the backup procedure from
the beginning (EDD) and then repeat the verification
procedure.
The data transfer was interrupted by a system timeout
BKP0008
or by a line problem, such as excessive noise.
Corrective action: Repeat the verification procedure.
The configuration database backup procedure is complete. Type
**** to exit the program.
Action
Type LD 143.
The system responds with the following:
CCBR
.
Nortel Communication Server 1000
Communication Server 1000E Maintenance
NN43041-700 01.02 Standard
Release 5.0 20 June 2007
Compare the file again with the XVR command.
If the verification fails again, repeat the backup
and reverify with the XVR command.
Check your communications package parameters.
Ensure that the parameter settings are correct:
Mode = binary; Protocol = Xmodem. Another
possible cause is that the communications
package is stripping characters.
—End—