Nortel 1000E Maintenance Manual page 26

26 Communicating with the system
Access through the maintenance telephone
The Call Server can be accessed using a maintenance telephone. A
telephone functions as a maintenance telephone when the class-of-service
is defined as Maintenance Telephone Allowed (MTA) in LD 11.
Using a maintenance telephone, you can send a subset of commands.
The maintenance telephone takes priority over a system terminal and logs
the terminal out.
Specific commands for testing tones and outpulsing through the
maintenance telephone are given in the Tone and Digit Switch and Digitone
Receiver Diagnostic (LD 34).
Specific commands for testing trunk connections through the maintenance
telephone are given in the Trunk Diagnostic (LD 36).
The following Maintenance Overlays are accessible from an IP Phone
operating as a maintenance telephone: 30, 32, 33, 34, 36, 37, 38, 41, 42,
43, 45, 46, 60, and 62.
Maintenance Overlay operations are supported on IP Phones except for the
Tone and Digit Switch (TDS) commands of LD 34 and TONE commands
of LD 46.
To use the maintenance telephone, the Terminal Number (TN) for that
telephone must be operating.
To access the system using the maintenance telephone, a Special Service
Prefix (SPRE) code, as defined in the Customer Data Block, is entered,
followed by "91". See
(page 27)
to the letters and numbers of the command (for example, to enter "LD 42,
Return", enter53#42##).
Table 1 "Translation from keyboard to dial pad" (page 26)
translation from a terminal keyboard to a telephone dial pad.
Table 1
Translation from keyboard to dial pad
Copyright © 2007, Nortel Networks
.
Procedure 2 "Accessing the maintenance telephone"
for details. To enter commands, press the keys that correspond
Keyboard
A B C
D E F
Nortel Communication Server 1000
Communication Server 1000E Maintenance
NN43041-700 01.02 Standard
Release 5.0 20 June 2007
shows the
Dial Pad
1
2
3
1
2
3