Nortel 1000E Maintenance Manual page 60

60 Software maintenance tools
However, a number of maintenance commands are either not supported or
not applicable to the MG 1000E.
for MG 1000E" (page 60)
the MG 1000Es.
Table 15
Unsupported overlay commands for MG 1000E
LD Unsupported commands
30
CPED, DISL, ENLL, LDIS, LENL, LOOP, RPED, SLFT, STEI, TIET, TTSM, and TTWI
32 DISL, DISN, DLIF, DSCT, DSNW, DSPS, DSRB, DSTS, DSXP, ENLG, ENLL, ENLN,
ENNW, ENPS, ENRB, ENTS, ESTU, FDIS, PCON, PERR, PLOG, PMES, PTAB, PTRF,
RLBT, RLSU, SDLC, STAT NCAL, STAT loop, STAT NWK, STAT PER, IDC loop,
IDCS, SUPL, XNTT, XPCT and XPEC
34 DTR and TDS
Also, the following Maintenance Telephone commands are not supported:
CDT, CMP, CUST, CWG, DRNG, DTD, ITN, JDRG, JIDT, ORD, PCRT and TST
38 DISX and ENLX
45
TEST
46
DISL, DISX, ENLL, ENLX and MFS
92 No supported commands (the Automatic Trunk Maintenance feature is not supported
in CS 1000E)
Error Monitor
The Error Monitor is a resident program that continuously tracks call
processing. The Error Monitor generates system messages if it detects
invalid or incorrectly formatted call processing information.
System messages generated by the Error Monitor are preceded by the
mnemonic ERR, which usually indicates hardware faults, or the mnemonic
BUG, which usually indicates software problems.
With prompt ERRM in the Configuration Record (LD 17), instruct the system
to print or not print ERR or BUG messages. If many similar BUG messages
occur, consult the Technical Assistance Center.
Initialize Program
The Initialize Program momentarily interrupts call processing when it clears
Core Equipment faults. It then rebuilds call-dependent data and generates
system messages with the mnemonic INI, which indicate the status of the
system.
Copyright © 2007, Nortel Networks
.
lists the commands that are not supported in
Nortel Communication Server 1000
Communication Server 1000E Maintenance
NN43041-700 01.02 Standard
Release 5.0 20 June 2007
Table 15 "Unsupported overlay commands