The Print Result Is Not What Was Expected - Fuji Xerox ApeosPort-V 3065 Administrator's Manual

Problem Solving

The Print Result is Not What was Expected

If the print result is not what was expected, identify the symptom in the following table to
perform the remedy.
15
456
Symptom
The data has The machine is out of
been sent to the paper.
machine.
No paper is loaded for the
specified paper size.
Printing is interrupted by a
copy operation.
An error occurred in the
machine.
Symptom
Outputs are not The Finisher is not
stapled. installed.
The number of pages
to be stapled exceeds
the maximum number
for stapling.
The document is The document size is
printed on a different from the
different paper size paper size loaded in
than specified. the specified tray.
The image on the The image is larger
document edges is than the printable
missing on the area.
output.
The printed font Font replacement is
differs from the font set on the print driver.
specified on the
computer.
The printout is not The machine does not
offset. offer the Offset
feature.
The specified print The print driver for
options are not another model is used.
enabled.
The required optional
kit is not installed on
the machine.
The document The image is larger
edges are missing than the printable
on the printout. area.
Cause
Load paper in the machine.
Load paper of the size specified.
Reference
Refer to "Loading Paper" (P.58).
Cancel the interrupting operation.
Check the error details and take an
appropriate action.
Cause
The Finisher is required to staple. Install
the Finisher, or change the print option
settings to cancel stapling.
You cannot staple more than 50 pages.
Reduce the number of pages to 50 or
fewer.
Change the size of paper in the tray, or
change the print option to specify a tray
that contains the correct sized paper.
Expand the printable area of the machine,
or reduce the image size on the printout.
Check the font replacement table.
To output offset, the Offset Stacking
Module or the Finisher is required.
Install the print driver for the model.
Check the optional components installed
on the machine, and set [Installable
Options] under [Configuration] in the print
driver again.
Expand the printable area of the machine,
or reduce the image size on the printout.
Remedy
Remedy