Step 2 Configuring The Sip User Name - Fuji Xerox ApeosPort-V 3065 Administrator's Manual

obtained automatically, or if manual configuration is preferred, confirm the settings of an
IP address, a subnet mask, and a gateway address.
Reference
For information on how to set an IP address, refer to "Protocol Settings" (P.177).
4
Select [Close] repeatedly until the [Tools] screen is displayed.
5
Select [Close].
Note
Rebooting the machine may be required depending on the settings. When a message displayed on the
screen, follow the message and reboot the machine.
6
Print a configuration report to confirm that the port is enabled and TCP/IP setting is set up
correctly.
Reference
For information on how to print a configuration report, refer to "Print Reports" (P.95).

Step 2 Configuring the SIP User Name

This section describes the configuration procedures of the SIP user name on the machine.
Reference
You can configure the settings using CentreWare Internet Services. For information on how to use CentreWare Internet Services,
refer to "Configuring Machine Settings Using CentreWare Internet Services" (P.313).
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note
The default user ID is "11111".
The default passcode is "x-admin".
3) Select [Tools] on the Services Home screen.
2
Set SIP User ID.
1) Select [Connectivity & Network Setup].
2) Select [SIP settings].
3) Select [SIP User ID (Sign-in Name)], and then select [Change Settings].
4) Enter a SIP User ID and select [Save].
Reference
For information on SIP User ID, refer to "SIP Settings" (P.186).
3
Select [Close] repeatedly until the [Tools] screen is displayed.
Installation Procedures
369
10