Table of Contents
Advertisement
Appendix
The hard clip area can be set either with HP-GL emulation mode settings or by the specified
hard clip command "&I".
The following coordinate values present an example of when the origin is set at the lower
left (Auto Layout in HP-GL/2) of A3 sheet.
+Y
Standard
Defines the printable area of the machine as the hard clip area.
Printable Area
The printable area in the HP-GL mode is as follows:
16
676
Defines a size same as the paper size as the hard clip area. However, the area that allows
actual printing is within the printable area.
Standard Hard Clip Area
Paper Hard Clip Area
(0, 0) Standard origin
(0, 0) Paper origin
Paper Size
(16798, 11876)
(16442, 11520)
+X
Advertisement
Table of Contents
