Table of Contents
Advertisement
Maintenance
Replacing Staple Cartridge (for Finisher-A1)
When the optional Finisher-A1 is installed and the staple cartridge needs to be replaced, a
message appears on the touch screen. When this message appears, load a new staple case
into the staple cartridge.
Important
Note
1
3
Make sure that the machine is not operating, and open the finisher front door.
2
Take the staple cartridge out of the finisher.
3
After you take out the staple cartridge, check inside of the finisher for any remaining
staples.
74
Images output from the machine may get dirty after the message "Please order Drum Cartridge" appears on
the touch screen.
The use of staple cartridges not recommended by Fuji Xerox may degrade quality and performance. Use only
staple cartridges recommended by Fuji Xerox.
When the machine is in the Power Saver mode, exit the Power Saver mode by pressing the <Power Saver>
button and the <Machine Status> button on the control panel before you replace the staple cartridge.
When replacing the staple cartridge, press the <Machine Status> button and check the current status for the
staple cartridge even when the control panel is lit.
To order a staple cartridge, contact our Customer Support Center.
Advertisement
Table of Contents
