Ars/F-Route Table - NEC SL1100 Programming Manual

SL1100
Level:
IN
Description
Use Program 44-05 : ARS/F-Route Table to set the ARS/F-Route table. There are four kinds of
Program
order. If the higher priority trunk groups are busy, the next order group is used. If a lower priority route
is selected, the caller may be notified with a beep tone.
44
Input Data
Item
No.
01 Trunk Group Number
02 Delete Digits
03 Additional Dial Num-
ber Table
04 Beep Tone
05 Gain Table Number
for Internal Calls
06 Gain Table Number
for Tandem Connec-
tions
07 ARS Class of Service
08 Dial Treatment
09 Maximum Digit
11 Network Specified Pa-
rameter Table
2-394
Program 44 : ARS/F-Route Setup
ARS/F-Route Table Number
Priority Number
Item Input Data
0 = No Setting
1 ~ 25 = Trunk Group
101 ~ 104 = Networking
(V1.5 Added)
255 = Extension Call
0 ~ 255
(255 = Delete All)
0 ~ 100
0 = Off
1 = On
0 ~ 100
0 = No Setting
0 ~ 100
0 = No Setting
0 ~ 16
0 = No ARS Class (Call
Restricted)
0 ~ 15
0 ~ 24
0 ~ 16

44-05 : ARS/F-Route Table

Description
Select the trunk group number to use for
the outgoing ARS call.
Enter the number of digits to be deleted
from the dialed number.
Enter the table number (defined in Pro-
gram 44-06) for additional digits to be di-
aled.
Select whether or not a beep is heard if a
lower priority trunk group is used to dial
out.
Select the gain table number to use for the
internal call (defined in Program 44-07).
Select the gain table number to use for the
tandem call (defined in Program 44-07).
Select the ARS Class of Service to use for
the table. An extension ARS COS is deter-
mined in Program 26-04-01.
Select the Dial Treatment to use for the ta-
ble. If a Dial Treatment is selected, Pro-
grams 44-05-02 and 44-05-03 are ignored
and the Dial Treatment defined in Program
26-03-01 is used instead.
Input the maximum number of digits to
send when using the F-Route.
Enter a table number from Program 26-12.
Program 44 : ARS/F-Route Setup
ISSUE 4.0
001 ~ 100
1 ~ 4
Default
0
0
0
0
0
0
0
0
0
0