Ars Dial Treatment - NEC Xen Topaz Programming Manual

Program 26 to 35
IN
SA
SB
Description
Use Program 26-03 : ARS Dial Treatments to assign the 15 Dial Treatments for automatic ARS Dialling
translation. Assign Dial Treatments to Service Numbers (Trunk Groups) in Program 26-02.
The ARS Dial Treatment options are:
• 3 - Delete the NPA if dialled as part of the initial call.
• 2 - Delete the leading digit if dialled as part of the initial call.
• 1 - Add a leading 1 if not dialled as part of the initial call.
• INPA - Insert the NPA specified by NPA.
• DNN - Outdial the NN number of digits or execute the code that follows. For example, D041234 out-dials
1234. Valid entries are 0-9, #, *, Wnn (wait nn seconds) and P (pause). Each digits code counts as a digit.
So for example, if a P was added for a pause, the entry would look like: D05P1234. This Dial Treatment can
only be added from telephone programming.
• Wnn - Wait nn seconds.
• P - Pause in analogue trunk.
• R - Redial the initially dialled number, including any modifications
• E - End of Dial Treatment. All Dial Treatments must end with the E code.
Input Data
Dial Treatment
Prog. No.
Table Number
26-03-01
1-15
Conditions
None
Feature Cross Reference
♦
Automatic Route Selection
Telephone Programming Instructions
To enter data for Program 26-03(ARS Dial Treatments):
1. Enter the programming mode.
2. Enter 26 03
26-03-01ARS-T1
3. Enter the number of the item you want to program.
26-03-xxARS-Txx
xxxxx
4. Select the Dial Treatment Table number to be programmed by pressing the FLASH or the VOLUME▲ or
VOLUME▼ keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you've exited that series' programming section
P 26: ARS S
ROGRAM
Input Data
Max. 36 characters
& L
ERVICE EAST
26-03: ARS D
Default
No setting
Xen Topaz Programming Manual
C R
OST OUTING
T
IAL REATMENT
Related
Program
26-02
225