Ars Dial Treatments - NEC SL1100 Programming Manual

ISSUE 4.0
Level:
IN
Description
Use Program 26-03 : ARS Dial Treatments to assign the 15 Dial Treatments for automatic ARS
dialing translation. Assign Dial Treatments to Service Numbers (Trunk Groups) in Program 26-02. The
ARS Dial Treatment options are:
• An - For Alternate Carrier Access (n = 1 ~ 4). The numeric digit instructs the system to insert a
Transit Network Selection information element in the SETUP message and also identifies which
code in Program 26-11 will be included in the information element. This function is valid only for
outbound calls by ISDN trunks.
• DNN - Outdial the NN number of digits or execute the code that follows. For example, D041234
outdials 1234. Valid entries are 0 ~ 9, #,
counts as a digit. So, for example, if a P was added for a pause, the entry would look like :
D05P1234.
• Wnn - Wait nn seconds.
• P - Pause in analog trunk.
• R - Redial the initially dialed number, including any modifications.
• E - End of Dial Treatment. All Dial Treatments must end with the E code.
• X - When ARS is enabled, X must be entered in the Dial Treatment for the system to output the
extension number of the call originator to the black box for the E911 feature.
Input Data
Dial Treatment Table Number
Item Item
No.
01 Treatment Code
Conditions
None
Feature Cross Reference
• Automatic Route Selection (ARS/F-Route)
Programming Manual
Program 26 : ARS Service

26-03 : ARS Dial Treatments

* , Wnn (wait nn seconds) and P (pause). Each digits code
Input Data
Maximum 36 characters
SL1100
1 ~ 15
Default
No Setting
2-307
Program
26