Ricoh D146 Service Manual page 1361

Main SP Tables-6
001 -
[Skew Correction Moving Setting]
With default setting, original buckling (Skew correct 2) to ADF scanning
6020
entrance roller is only done for small sizes (B6, A5, HLT). With setting "1", this
buckling can be done to all sizes.
001 -
[Sub-scanPunchPosAdj:2K/3K FIN]
§
Adjusts position of carry direction (sub scan direction) for punch. Adjusting
6100
value to -: hole position moves toward trailing edge of paper when intaking.
§
Adjusting value to +: hole position moves toward leading edge of paper
when intaking.
001 JPN/EU: 2-Hole
002 NA: 3-Hole
003 Europe: 4-Hole
004 NEU: 4-Hole
005 NA: 2-Hole
[Main-scanPunchPosAdj:2K/3K FIN]
Adjusts position of width direction (main scan direction) for punch.
6101
§
Adjusting value to -: hole position moves toward front side of machine.
§
Adjusting value to +: hole position moves toward rear side of machine.
001 JPN/EU: 2-Hole
002 NA: 3-Hole
003 Europe: 4-Hole
004 NEU: 4-Hole
005 NA: 2-Hole
D146/D147/D148/D149/D150
*ENG [-5.0 to 5.0 / 0.0 / 0.1 %/step]
*ENG [0 or 1 / 0 / 1/step]
ENG
ENG
ENG [-7.5 to 7.5 / 0.0 / 0.5mm/step]
ENG
ENG
ENG
ENG
ENG [-2.0 to 2.0 / 0.0 / 0.4mm/step]
ENG
ENG
2-642 System Maintenance Section