Error Screens During Updating - Ricoh D146 Service Manual

5.4 ERROR SCREENS DURING UPDATING

EXX shows an error code.
(This error is generated if update was performed when a printer application startup card is
removed after system startup. An error indicating failure of card access is displayed on the
screen.)
For error codes, refer to the following table:
Error Code List
Code
Physical address mapping
20
cannot be performed.
Memory acquisition cannot be
21
performed.
Compressed data
22
decompression failure.
ROM update program startup
23
error
24 Card access error
During print download, there
30
is no HDD.
Data during download
31
continuation is not correct.
Data during download
32
interrupt is not correct.
System Maintenance Section
Contents
1.
2.
1.
2.
The ROM update data in the SD card is
incorrect or damaged.
Controller program fault.
Controller program reinstallation, or
controller board replacement
1.
2.
1.
2.
Insert the SD card containing continuation
target module data. Reinstallation required.
Insert the SD card containing recovery
target module data after interruption.
Reinstallation required.
5-9
Error screens during updating
Solutions
Reinsert the SD card.
Replace the SD card.
Connect the HDD correctly.
Replace the HDD.
Reinsert the SD card.
Replace the SD card.
Connect the HDD correctly.
Replace the HDD.
D146/D147/D148/D149/D150