[External Controller Info. Settings]
5193
External controler settings.
001 -
[Limitless SW]
5195
Switches productivity precede limit less feed and use paper up limit less feed.
001 -
[Copier Vendor Mode]
5196
-
001 90 deg. Rotation
002 Color and Tray Selection
[Paper Exit After Staple End]
Enables or disables the paper feeding out from the finisher without stapling.
§
If this setting is "1: ON", paper is fed out without stapling at the maximum
number of the finisher stapling when the machine gets a multiple printing
5199
job (over maximum number).
§
If this setting is "0: OFF", paper is fed out with stapling at the maximum
number of the finisher stapling when the machine gets a multiple printing
job (over maximum number).
System Maintenance Section
[0 to 10 / 0 / 1/step]
0: External Controller is not
installed
1: EFI
2: Ratio
CTL
3: Egret
4: GJ
5:Creo
6: QX-100
7: Kurofune
8 to 10: Reserved
[0 or 1 / 0 / 1/step]
*CTL
0: Productivity Precede
1: Use paper up
CTL
[- / - / -]
CTL
[- / - / -]
2-563
D146/D147/D148/D149/D150
Main SP Tables-5