Ricoh D146 Service Manual page 1825

Code
0-05 Modem training fails even G3
shifts down to 2400 bps.
0-06 The other terminal did not
reply to DCS
0-07 No post-message response
from the other end after a
page was sent
SM
Meaning Suggested Cause/Action

Check the line connection.

Try adjusting the tx level and/or cable
equalizer.

Replace the FCU.

Check for line problems.
Cross reference
See error code 0-04.

Check the line connection.

Try adjusting the tx level and/or cable
equalizer settings.

Replace the FCU.

The other end may be defective or
incompatible; try sending to another
machine.

Check for line problems.
Cross reference
See error code 0-04.

Check the line connection.

Replace the FCU.

The other end may have jammed or run
out of paper.

The other end user may have
disconnected the call.

Check for a bad line.

The other end may be defective; try
sending to another machine.
49 D163