Ricoh D146 Service Manual page 1609

Error screens during updating
Code
33 Card version is not correct.
There is no module which
34
matches the destination.
There is no module
35
corresponding to the module.
For another reason, there is
36
no rewrite target module.
Motor download execution
40
malfunction
Control unit download
42
execution malfunction
Print download execution
43
malfunction
Controller download
44
execution malfunction
Electronic authentication
50
check NG
§
The PDF firmware installed as standard contains a program required to print PS3 data as
default. However, this PS3 program is normally disabled.
§
The PS3 firmware is a dongle (key) which enables PS3 data printing functions. When the
PS3 firmware is installed, the PS3 program in the PDF firmware is enabled. Due to this
specification, the self-diagnosis result report shows the ROM part number/software
version of the PDF firmware contained in the PS3 program.
D146/D147/D148/D149/D150
Contents Solutions
ROM data in the SD card is incorrect or
damaged.
Re-enter ROM update data with correct
destination (domestic/overseas/OEM) in
the SD card.
Re-enter ROM update data for the correct
device in the SD card.
Re-enter ROM update data for the correct
device in the SD card.
Re-enter the data in the SD card.
Alternatively, replace the engine circuit
board. Reinstallation required.
Re-enter data in the SD card. Alternatively,
replace the control unit board.
Reinstallation required.
Re-enter data in the SD card. Alternatively,
replace the HDD. Reinstallation required.
Re-enter data in the SD card. Alternatively,
replace the controller board. Reinstallation
required.
Re-enter ROM update data for the correct
device in the SD card.
5-10 System Maintenance Section