Ricoh D146 Service Manual page 1526

Rev. 8/12/2014
1001 [Bit Switch]
011 Bit Switch B
bit 0 Show Menu List
If this is 0, the Menu List button will be removed from Printer Features.
bit 1
Print job interruption
0 (default): Print jobs are not interrupted. If a job is promoted to the top of
the print queue, it will wait for the currently printing job to finish.
1: If a job is promoted to the top of the queue, it will interrupt the currently
printing job and start printing immediately.
bit 2 DFU
bit 3 Change the behavior of the center staple
⇒
This Bit Switch can change the behavior of the center staple when the maximum
number of sheets for stapling has been exceeded.
0 (default): The job is canceled and an error is recorded in the Error Log.
1: The job is not canceled and is produced. How the job is produced in any behavior
depends on the type of finisher.
NOTE: This Bit Switch applies only to jobs with center stapling. 12A controller–based
devices do not have a way to change the behavior of jobs with edge or corner stapling.
bit 4 DFU
bit 5 DFU
bit 6 DFU
bit 7 DFU
1001 [Bit Switch]
012 Bit Switch C
bit 0 DFU
bit 1 DFU
bit 2 DFU
bit 3 DFU
bit 4 DFU
bit 5 DFU
System Maintenance Section
0
Hide Menu
List
Does not
allow
interruption
-
Cancel the
job
-
-
-
-
0
-
-
-
-
-
-
2-807 D146/D147/D148/D149/D150
Printer SP Mode
1
Show Menu
List
Allow
interruption
-
Continue to
print
-
-
-
-
1
-
-
-
-
-
-