Ricoh D146 Service Manual page 1844

Code
15-95 Transfer Station Function
16-00 No IP address registered
22-00 Original length exceeded the
maximum scan length
22-01 Memory overflow while
receiving
22-02 Tx or rx job stalled due to line
disconnection at the other end
22-04 The machine cannot store
received data in the SAF
22-05 No G3 parameter confirmation
answer
23-00 Data read timeout during
construction
D163
Meaning Suggested Cause/Action

The machine rejected an incoming e-mail
for transfer because the transfer function
was unavailable.

The machine does not get an IP address
because the DNS server has not been
registered for the remote machine or IP
address of the remote machine has not
been registered.

Register the DNS server for the remote
machine or configure an IP address of the
remote machine.

Divide the original into more than one
page.

Check the resolution used for scanning.
Lower the scan resolution if possible.

Add optional page memory.

Wait for the files in the queue to be sent.

Delete unnecessary files from memory.

Transfer the substitute reception files to an
another fax machine, if the machine's
printer is busy or out of order.

Add an optional SAF memory card or hard
disk.

The job started normally but did not finish
normally; data may or may not have been
received fully.

Restart the machine.

Update the ROM

Replace the FCU.

Defective FCU board or firmware.

Restart the machine.

Replace the FCU.
68 SM