Ricoh D146 Service Manual page 1305

Main SP Tables-5
Function Flag
003
Enables or disables the remote service function.
SSL Disable
007
Controls if RCG (Remote Communication Gate) confirmation is done by SSL
during an RCG send for the @Remote over a network interface.
RCG Connect Timeout
008
Sets the length of time (seconds) for the time-out when the RCG (Remote
Communication Gate) connects during a call via the @Remote network.
RCG Connect Timeout
008
Sets the length of time (seconds) for the time-out when the RCG (Remote
Communication Gate) connects during a call via the @Remote network.
RCG Write Timeout
009
Sets the length of time (seconds) for the time-out when the RCG (Remote
Communication Gate) connects during a call via the @Remote network.
RCG Read Timeout
010
Sets the length of time (seconds) for the timeout when sent data is written from
the RCG during a call over the @Remote network.
Port 80 Enable
011
Controls if permission is given to get access to the SOAP method over Port 80
on the @Remote network.
RFU Timing
013
Selects the timing for the remote firmware updating.
D146/D147/D148/D149/D150
[0 or 1 / 0 / 1/step]
*CTL 0: Disabled
1: Enabled
[0 or 1 / 0 / 1/step]
*CTL 0: Yes. SSL not used.
1: No. SSL used.
*CTL [1 to 90 / 30 / 1second/step]
*CTL [1 to 90 / 30 / 1second/step]
*CTL [0 to 100 / 60 / 1second/step]
*CTL [0 to 100 / 60 / 1second/step]
[0 or 1 / 0 / 1/step]
*CTL 0: No. Access denied
1: Yes. Access granted.
[0 or 1 / 1 / 1/step]
*CTL 0: Any status of a target machine
1: Sleep or panel off mode only
2-586 System Maintenance Section