Ricoh D146 Service Manual page 1851

12 G3 fax is connected to VoIP gateway?
13 Remote G3 fax turned on?
14 Network bandwidth too narrow?
Cannot send by Alias Fax number.
Check Point
1 LAN cable connected?
2 Number of specified Alias fax correct?
3 Firewall/NAT installed?
4 Transmission sent manually?
5 Gatekeeper/SIP server installed correctly? Contact the network administrator.
Gatekeeper/SIP server power switched
6
on?
IP address/host name of Gatekeeper/SIP
7
server correct?
DNS server registered when
8 Gatekeeper/SIP server host name
specified?
SM
Check that G3 fax is connected.
Check that G3 fax is switched on.
Request the network administrator to
increase the bandwidth.
Raise the network delay level.
IPFAX SW 01 Bit 0 to 3
IP-Fax bandwidth is the same as the
DCS speed. Set IP-Fax SW00 Bit 6 to
1.
Action
Check the LAN cable connection.
Confirm the Alias of the remote fax.
Error Code: 13-14
Cannot breach the firewall. Send by
using another method (Fax, Internet
Fax)
Manual sending not supported.
Contact the network administrator.
Check the IP address/host name.
Contact the network administrator.
75 D163