Removing And Installing Gearbox Mounting And Gearbox Support; Removing And Installing Gearbox Mounting And Gearbox Support (Left-Side) - Audi A8 2003 Workshop Manual

Audi A8 2003 ➤
multitronic 01J, front-wheel drive - Edition 11.2007
8 Removing and installing gearbox
mounting and gearbox support
♦ ⇒ "8.1 Removing and installing gearbox mounting and gear‐
box support (left-side)", page 60
♦ ⇒ "8.2 Removing and installing gearbox mounting and gear‐
box support (right-side)", page 62
8.1 Removing and installing gearbox
mounting and gearbox support (left-
side)
Special tools and workshop equipment required
♦ Engine and gearbox jack -V.A.G 1383 A-
Removing
– If applicable, activate jacking mode when raising the vehicle
⇒ Running gear, front-wheel drive and four-wheel drive; Rep.
Gr. 43 ; Adaptive air suspension .
– Raise vehicle or drive onto inspection pit.
– On vehicles fitted with auxiliary heater, remove screws
-arrows- securing exhaust pipe of auxiliary/ additional heater
to noise insulation.
– Release quick-release fasteners -1- and -2- and detach noise
insulation panels.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
60
Rep. Gr.37 - Controls, housing