Audi A8 2003 Workshop Manual page 97

– Remove bolts -3- at support bracket for selector lever cable.
– Use removal lever -80-200- to prise ball head -1- on selector
lever cable off selector shaft lever -arrow-.
Note
-Item 2- can be disregarded.
– Release electrical connector -arrow- and detach from gear‐
box.
– Remove bolts -arrows- and take off end cover.
Note
Fit new bolts when installing.
Installing
Installation is carried out in reverse sequence; note the following:
Note
Renew gaskets and seals.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
multitronic 01J, front-wheel drive - Edition 11.2007
1. Dismantling and assembling gearbox
Audi A8 2003 ➤
93