Audi A8 2003 Workshop Manual page 81

Removing
Note
General repair instructions
♦
Rules for cleanliness when working on the automatic gearbox
♦
⇒ page 9 .
Before fitting a new gearbox, always blow through the ATF
♦
cooler and ATF pipes with compressed air (not more than
10 bar) ⇒ page 75
ATF which emerges during cleaning is very dirty, the pipes and
ATF cooler must additionally be flushed out with clean ATF.
To install, first press ATF pipes onto gearbox or cooler by hand
♦
until they engage, then bolt on.
– If applicable, activate jacking mode when raising the vehicle
⇒ Running gear, front-wheel drive and four-wheel drive; Rep.
Gr. 43 ; Adaptive air suspension .
– Raise vehicle.
– On vehicles fitted with auxiliary heater, remove screws
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
-arrows- securing exhaust pipe of auxiliary/ additional heater
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG. to noise insulation.
– Release quick-release fasteners -1- and -2- and detach noise
insulation panels.
– Place used oil collection and extraction unit -V.A.G 1782- be‐
low gearbox.
⇒ page 7 .
and renew the additional ATF filter. If the
multitronic 01J, front-wheel drive - Edition 11.2007
10. Servicing ATF cooling system on vehicles with 3.0 ltr. MPI engine
Audi A8 2003 ➤
77